ND 1200 QUADRA-CHEK 23
1.2 Basic Functions of the ND 1200
Feature evaluation mode screens and soft keys
The feature evaluation screens can be toggled between two displays
by pressing the VIEW soft key to show:
Feature list of measured features on the left side
Unit of measure, current datum and probe type in the upper right
corner
The feature type and number of the highlighted feature
Feature position
Geometric and dimensional values such as diameter, length or angle
Number of data points used to define the feature
Form error
Parent features used if the feature was constructed
An indication that the feature was created if applicable
Data cloud of collected data points used to define the feature
Feature evaluation mode screen showing feature
values
Feature evaluation mode screen showing data points
DRO soft keys Function
Recall Displays a different feature from the feature list
by specifying its feature number.
View Toggles between the default screen showing
axis values and the screen showing data points
collected to define the feature.
Change Shows alternative fit algorithms for the current
feature type, such as LSBF (least squares best
fit) and ISO.
Zoom Changes magnification when viewing the data
cloud of collected data points.
Tol Displays the alternative tolerances that can be
applied to the current feature.
Tolerances are discussed later in this chapter.
To Next Page
Loading...
