130 2 Installation and Specifications
2.3 Software setup
Audio configuration
The ND 1200 can be configured to generate a sound in response to
certain measurement activities and results.
Sounds screen
The Sounds screen contains choice fields for enabling or disabling
audio beeps in response to:
Warning: Any warning shown on the screen
Point entry: When a point is entered during measurement
Begin measure: Immediately prior to a measurement during a
program execution
Good result: When a measurement passes all tolerance tests
Failed result: When a measurement fails a tolerance test
Excess form: Form error in excess of factory default values. These
values cannot be changed and represent extreme form errors. This
function is intended as a precautionary alert.
All audio responses are alerts and are enabled using the same method.
To enable an audio alert:
U Press MENU/SETUP to display the setup menu and then highlight
the Sounds menu item.
U Highlight the desired audio alert choice field and then press the
SIMPLE soft key to enable the alert or press the NONE soft key to
disable it.
The volume of all audio responses can be changed simultaneously
from silence to loud. To adjust the volume of all audio alerts:
U Highlight the Volume data field and enter a value from 0 to 10. A
value of 0 will silence alerts. Alert volume increases from 1 to 10.
U Press the FINISH key to return to the setup menu.
Highlight the desired alert choice field
and Press the SIMPLE soft key to enable
the alert.
Highlight the Volume data field and enter
a value to adjust the loudness of all alerts
To Next Page
Loading...
