ND 1200 QUADRA-CHEK 65
1.8 Programming
Example of changing program properties
In this example, program properties will be edited to change the
behavior of the program when a tolerance fails. Initially, the program
pauses when a tolerance fails; after the change, the program will not
pause:
To change program properties:
U Use the ARROW CURSOR keys to highlight the Prg Properties step.
U Press the ENTER key to expand the Prg Properties step.
U Use the ARROW CURSOR keys to highlight the Pause Tol Results
step.
U Press the NEVER soft key and then the ENTER key to change the
Pause Tol Results step value from If Fail to Never.
U Press the FINISH key to save to change and return to the Programs
screen.
The Prg Properties step is highlighted
and expanded
The Pause Tol Results step is highlighted The NEVER soft key and then ENTER
key to change from If Fail to Never
To Next Page
Loading...
