4–60 TNC 370 D Machine Parameters July 02
4.6 Operation with Servo Lag
Machine
parameter
Function and input Change via Reaction
MP1710.0-3 Position monitoring for control with servo
lag (erasable)
Input: 0.000 to 1 000.000 [mm]
Recommended: 1.2 · servo lag
PLC
MP1720.0-3 Position monitoring for control with servo
lag (EMERGENCY STOP)
Input: 0.000 to 1 000.000 [mm]
Recommended: 1.4 · servo lag
PLC
MP1810.0-3
k
v
factor for control with servo lag
Input: 0.100 to 10.000 [Fehler ] !
PLC
MP1820.0-3 Multiplication factor for the k
v
factor
Input: 0.001 to 1.000
PLC
MP1830.0-3 Characteristic kink
Input: 0.000 to 100.000 [%]
PLC
4.7 Main Spindle
Machine
parameter
Function and input Change via Reaction
MP3010 Output of rotational speed, gear range
Input:
0 = no output of spindle speed
1 = coded output of spindle speed, only if
the speed changes
2 = coded output of spindle speed on each
TOOL CALL
3 = analog output of spindle speed, but
gear change signal only if the speed
changes
4 = analog output of spindle speed, but
gear change signal on each TOOL
CALL
5 = analog output of spindle speed, but no
gear change signal
6 = same as input value 3 but with
controlled spindle for orientation
7 = same as input value 4 but with
controlled spindle for orientation
8 = same as input value 5 but with
controlled spindle for orientation
Reset
MP3020 Speed range for S code output
Input: 0 to 99 999
(with analog output of the spindle speed,
enter 1991 here)
PLC
To Next Page
Loading...
