HEIDENHAIN TNC 370 D - Machining and Program Run

July 02 Machine Parameters TNC 370 D 4–75
Machine
parameter
Function and input Change via Reaction
MP7311 Drawing mode for editing graphics
Input: %xxxxxxxx
Bit 0 : 0/1 = do not indicate/indicate infeed
points
Bit 1 : 0/1 = do not draw/draw pocket
meanders
Bit 2 : 0/1 = do not draw/draw compensated
contours
Bit 3-7 Reserved
CN
MP7330.0-15 Definition of parameters as user parameters
Input: 0 to 9999.99 (no. of the desired
machine parameters)
PLC
RUN
MP7340.0-15 Dialogs for user parameters
Input: 0 to 199 (line number in the PLC
dialog file)
PLC
RUN
4.14 Machining and Program Run
Machine
parameter
Function and input Change via Reaction
MP7410 Scaling factor cycle in two or three axes
Input:
0 = Scaling factor cycle effective in all three
primary axes
1 = Scaling factor cycle effective only in the
working plane
CN
PLC
RUN
MP7411 Tool data in touch probe block
Input:
0 = With the touch probe block the current
tool data are overwritten with the
calibrated data of the probe system.
1 = The current tool data are retained even
with a touch probe block.
CN
PLC
RUN
MP7415.0 Type of transition element with M112
Input: %000000xx
(recommended input value %00000011)
0 = insert circular arc
1 = insert cubic spline
2 = insert 5
th
degree polynomial
3 = insert 7
th
degree polynomial
Bits 2 to 7 Reserved