HEIDENHAIN TNC 370 D - Page 75

4–72 TNC 370 D Machine Parameters July 02
Machine
parameter
Function and input Change via Reaction
MP7260 Number of the tools in the tool table
Input: 0 to 254
CN
MP7261 Number of pockets in the tool magazine
Input: 0 to 254
CN
MP7266
MP7266.0
MP7266.1
MP7266.2
MP7266.3
MP7266.4
MP7266.5
MP7266.6
MP7266.7
MP7266.8
MP7266.9
MP7266.10
MP7266.11
MP7266.12
MP7266.13
MP7266.14
MP7266.15
MP7266.16
MP7266.17
MP7266.18
MP7266.19
MP7266.20
MP7266.21
Elements of the tool table
Input:
0 = no display
1 to 99 = position in the tool table
Tool name (NAME)
Tool length (L)
Tool radius (R)
Free
Oversize for tool length (DL)
Oversize for tool radius (DR)
Free
Tool locked? (TL)
Replacement tool (RT)
TIME 1
TIME 2
CURRENT TIME
Comment about the tool (DOC)
Number of tool teeth (CUT)
Wear tolerance for tool length (LTOL)
Wear tolerance for tool radius (RTOL)
Cutting direction of the tool (DIRECT)
PLC status (PLC)
Tool offset for length (TT: L-OFFS)
Tool offset for radius (TT: R-OFFS)
Breakage tolerance for tool length
(LBREAK)
Breakage tolerance for tool radius
(RBREAK)
CN
MP7267
MP7267.0
MP7267.1
MP7267.2
MP7267.3
MP7267.4
Elements of the pocket table
Input:
0 = no display
1 to 99 = position in the pocket table
Tool number (T)
Special tool (ST)
Fixed pocket (F)
Locked pocket (L)
PLC status (PLC)
CN