HEIDENHAIN TNC 370 D - Page 85

5–82 TNC 370 D List of Markers and Words July 02
Marker S R
M4054 Battery voltage too low (battery warning at touch probe connection);
evaluated only during the probing process
NC NC
M4055 Enabling the probing process NC PLC
M4056 NC stop in all operating modes if stylus is deflected PLC PLC
M4060 Cycle for tool measurement started NC NC
M4061 0 = tool measurement
1 = tool inspection
NC NC
M4062 0 = wear tolerance not exceeded
1 = wear tolerance exceeded
NC NC
M4063 0 = breakage tolerance not exceeded
1 = breakage tolerance exceeded
NC NC
Strobe Si
g
nals from the NC to the PLC
M4070 Strobe signal for gear code NC NC
M4071 Strobe signal for S code NC NC
M4072 Strobe signal for M function NC NC
M4073 Strobe signal T code (P code) with TOOL CALL NC NC
M4074 Strobe signal T code (P code) with TOOL DEF NC NC
M4075 Transfer with FN19 active NC NC
Acknowled
g
ment of NC Strobe Si
g
nals
M4090 Acknowledgment "gear change completed" PLC PLC
M4091 Acknowledgment of S code PLC PLC
M4092 Acknowledgment of M code PLC PLC
M4093 Acknowledgment of T code (P code) with TOOL CALL PLC PLC
M4094 Acknowledgment of T code (P code) with TOOL DEF PLC PLC
M4095 Acknowledgment of transfer with FN19 PLC PLC
Strobe Si
g
nals from the PLC to the NC
M4120 PLC positioning axis X active PLC NC;
PLC
M4121 PLC positioning axis Y active PLC NC;
PLC
M4122 PLC positioning axis Z active PLC NC;
PLC
M4123 PLC positioning axis 4 active PLC NC;
PLC
M4130 Activation of PLC positioning for spindle orientation PLC NC
M4131 Activation of transfer of the value from D528 to the Q parameter defined
in W516
PLC NC
M4132 Activate datum shift from D528 to D544 PLC NC
M4134 Activation of a gear range and speed through the PLC PLC NC
M4135 Activation of the selected traverse range (M2816/M2817) PLC NC