December 2001 List of Machine Parameters 4 – 67
MP7650 Counting direction for handwheel
Format: %xxxxxxxxx
Input: 0: Negative counting direction
1: Positive counting direction
from
280 474-07
bit-coded
PLC
RUN
6 – 381
MP7660 Threshold sensitivity for electronic handwheel
Input: 0 to 65 535 [increments]
PLC
RUN
6 – 381
MP7670 Interpolation factor for handwheel
Input: 0 to 10
PLC
RUN
6 – 381,
6 – 384
MP7670.0 Interpolation factor for low speed
MP7670.1 Interpolation factor for medium speed
(only HR 410)
MP7670.2 Interpolation factor for high speed
(only HR 410)
MP7671 Handwheel feed rate in the Handwheel operating mode
with HR 410
Input: 0 to 1000 [% of MP1020]
PLC
RUN
6 – 384
MP7671.0 Low speed
MP7671.1 Medium speed (only HR 410)
MP7671.2 High speed (only HR 410)
MP Function and input Software
version and
behavior
Page
To Next Page
Loading...
