HEIDENHAIN TNC 426 PB - Example of a Log Entry

December 2001 Display and Operation 6 – 335
You can read out the log in two ways:
7
77
7 After entering the code word LOGBOOK, enter the path and name of an
ASCII file and the time and date from which the log should begin recording.
After that, an ASCII file is generated and opened with the log entries.
7
77
7 The PC software PLCdesign, TNCremo, or TNCremoNT offers you several
functions for reading out the log.
Example of a log
entry
The following example shows possible entries in the log:
Info: MAIN START 09:18:19 Mon Oct 09 2000
TNC 426/430 M
Info: MAIN START 09:18:19 Mon Oct 09 2000
NC SOFTWARE = 280476 10
Error: 09:18:29 Mon Oct 09 2000
N-1 Power interruption
Key: 0x01AE -> CE 09:41:37 Mon Oct 09 2000
Error: 09:41:40 Mon Oct 09 2000
P88 88 MPs being read
Key: 0x01F0 -> NC Start 09:41:46 Mon Oct 09 2000
Error: 09:41:46 Mon Oct 09 2000
P93 93 Feed rate override Poti=0!
Key: 0x01F0 -> NC Start 09:41:48 Mon Oct 09 2000
Stib: ON 09:41:57 Mon Oct 09 2000
Error: 09:41:57 Mon Oct 09 2000
P93 93 Feed rate override Poti=0!
Info: MAIN PATH 09:41:57 Mon Oct 09 2000
RUNTAB =
Stib: OFF 09:41:57 Mon Oct 09 2000
Info: MAIN PGMEND 09:41:57 Mon Oct 09 2000
01 02 03 04 05 06 07 08 09 0A 0B 0C 0D 0E 0F
00 05 00 08 00 00 00 38
Info: MAIN PATH 09:41:57 Mon Oct 09 2000
RUNBRKPGM = TNC:\STEFAN\NC\TEST.H
Error: 09:41:58 Mon Oct 09 2000
N56 Limit switch X+
Key: 0x01EC -> Screen Change 09:42:08 Mon Oct 09 2000
Byte 0 Byte 7