6 – 334 HEIDENHAIN Technical Manual TNC 426, TNC 430
Entry Description
INFO MAIN PATH PLCEDIT File for PLC Editor
NCEDIT File for NC Editor
RUNPGM Main program for program run
RUNPALET Pallet table for program run
RUNDATUM Datum table for program run
RUNTOOL Tool table for program run
RUNTCH Pocket table for program run
SIMPGM Main program for program test
SIMDATUM Datum table for program test
SIMTOOL Tool table for program test
RUNBRKPGM Stopping point for block scan
SIMBRKPGM Stopping point for program test
RUNPRINT Path for FN15: PRINT for program run
SIMPRINT Path for FN15: PRINT for program test
MDIPGM File for positioning with manual data input
NCFMASK Mask for file management in the NC area
PLCFMASK Mask for file management in the PLC area
EASYDIR Paths for standard file management
TCHPATH Datum table for manual measurement
SIMTAB Freely definable table in program test
RUNTAB Freely definable table in program run
KINTAB Active kinematic table
PGMEND Information about the program end in program run
Byte 0/1 00 01 Emergency stop
00 02 Positioning error
00 03 Programmed stop
00 04 Block end in single block
mode
00 05 Geometry error
00 06 END PGM, M02
00 07 TNC STOP button
00 08 Data transmission error
(V.24/V.11)
Byte 2/3 xx xx Internal error class
Byte 4...7 xx xx xx xx Internal error code
INFO
WARNING
ERROR
PLC <log identifier> Entries through PLC Modules 9275 and 9276
INFO REMO A_LG Log in with LSV2 protocol
REMO A_LO Log out with LSV2 protocol
REMO C_LK LSV2 protocol:
Locking and releasing the keyboard; the key codes
between locking and releasing are sent via LSV2
protocol
To Next Page
Loading...
