December 2001 Software Releases 2 – 47
n Module 9200/9201: Expanded (PLC soft keys can be appended to NC soft-
key rows)
n Module 9215: PLC pop-up window
n Module 9270: Read from OEM.SYS
n Module 9271: Write to OEM.SYS
n Automatic offset compensation of encoder signals
n Oscilloscope records can be saved in a file.
n MP7365.5: Selected channel in oscilloscope (input $00000FF)
NC software
280 472-02 (export
version 280 473-02)
Release: 07/97
Improvements:
n Cycle 32 changed to “tolerance”
n M134 new
n System file TNC.SYS new
n MP6500 expanded: Bit 10 probing routine, bit 11 tool checking and changing
the tool table
n MP7500 expanded: Bit 3 Setting the datum in a tilted coordinate system
n Editor for creating the format of freely definable tables
n FN18: ID200 and ID270 new
n FN17: ID350 new
n M4161 new
n PLC commands BTX, BCX and BSX new
NC software
280 472-03 (export
version 280 473-03)
Release: 08/97
Improvements:
n Spline blocks also in tilted working plane
n MP7680, bit 10 new (spline curve at compensated outside corners)
n The software also runs on the old hardware of the LE 426 CB/PA and
LE 430 CA/PA, but with reduced functions.
n Cycle 19: “Setup clearance” input box new
NC software
280 472-04 (export
version 280 473-04)
Release: 10/97
Improvements:
n Code words LSV2TIME0 to LSV2TIME2 new
n Module 9038 expanded by transfer value –1
n DR2 can be defined in TOOL CALL block
n Spindle DSP limits max. torque to 2.5 · rated torque
To Next Page
Loading...
