December 2001 Software Releases 2 – 53
n New timers T96 to T143
n New strings S4 to S7
n W266: Index number of a programmed indexed tool
n D604: Maximum possible spindle speed
n Module 9008: Read certain inputs of PLC input/output unit
n Module 9009: Set certain outputs of PLC input/output unit
n Module 9088: Display M functions in status window
n Module 9091: Determine line number of tool in tool table
n Module 9145: Automatic actual and nominal value transfer
n Module 9175: Activate spindle
n Module 9202: A PLC window can be activated if the table editor is active
n Two spindles can be operated alternately
n The active M functions can be displayed with the STATUS M FUNCT. soft
key.
n Indexed tools can be entered
n Program sections can be marked, deleted and copied in the NC editor
n ISO: Tool offsets can be entered when the tool number is programmed
n With M128 a feed rate can be entered for the maximum speed of the
compensation traverse for the linear axes
n Cycle 205: Universal pecking
n Cycle 206: Tapping
n Cycle 207: Rigid tapping
n Cycle 208: Helical finish milling
n Cycle 200: Dwell time at bottom of hole
n Cycle 203: Retraction path at chip breaking
n Cycle 220: Approach clearance height during machining
n Cycle 210, 211, 212, 213, 214, 215, 220, 221: Preposition with positioning
logic
n Cycle 410 to 418: Set datum not equal to zero
To Next Page
Loading...
