December 2001 Overview of Markers and Words 5 – 11
M 4040 Status display M07, M08, and M09
highlighted
PLC PLC 6 – 238
M 4041 Status display M07, M08, M09, MK PLC PLC 6 – 238
M 4042 Status display M07, M08, M09, MK PLC PLC 6 – 238
M 4050 Touch probe not ready, ready signal is
missing
NC NC 6 – 349
M 4051 Stylus deflected before start of probing
cycle
NC NC 6 – 349
M 4052 Stylus is deflected, probing process is
completed
NC PLC 6 – 349
M 4053 Probing process has been ended or
canceled
NC NC 6 – 349
M 4054 Battery voltage too low (battery warning at
touch probe connection); evaluated only
during the probing process
NC NC 6 – 349
M 4055 Enable the probing process NC PLC 6 – 349
M 4056 NC stop in all operating modes if stylus is
deflected
PLC PLC 6 – 349
M 4060 Cycle for tool measurement started NC NC 6 – 378
M 4061 0: Measure the tool
1: Check the tool
NC NC 6 – 378
M 4062 0: Wear tolerance not exceeded
1: Wear tolerance exceeded
NC NC/
PLC
6 – 378
M 4063 0: Breakage tolerance not exceeded
1: Breakage tolerance exceeded
NC NC/
PLC
6 – 378
M 4065 Workpiece dimensions are OK NC PLC 280 474-03 6 – 353
M 4066 Workpiece must be reworked NC PLC 280 474-03 6 – 353
M 4067 Workpiece is scrap NC PLC 280 474-03 6 – 353
M 4070 Strobe signal for gear code NC NC 6 – 189
M 4071 Strobe signal for S code NC NC 6 – 194
M 4072 Strobe signal for M functions NC NC 6 – 283
M 4073 Strobe signal T code (P code) with
TOOL CALL
NC NC 6 – 424,
6 – 440
M 4074 Strobe signal T code (P code) with
TOOL DEF
NC NC 6 – 424,
6 – 440
M 4075 Transfer active with FN19 NC NC 7 – 22
M 4090 Acknowledgment of ”gear change
completed”
PLC PLC 6 – 189
M 4091 Acknowledgment of S code PLC PLC 6 – 194
M 4092 Acknowledgment of M functions PLC PLC 6 – 283
M 4093 Acknowledgment of T code (P code) with
TOOL CALL
PLC PLC 6 – 424,
6 – 440
M 4094 Acknowledgment of T code (P code) with
TOOL DEF
PLC PLC 6 – 424,
6 – 440
M 4095 Acknowledgement of transfer with FN19 PLC PLC 7 – 22
Marker Description Set Reset SW Vers. Page
To Next Page
Loading...
