6 – 500 HEIDENHAIN Technical Manual TNC 426, TNC 430
12. Run the circular test:
With the circular test you can check the exact input values for compensating
sliding friction:
7
77
7 Determine the radial acceleration:
MP1070 = 0.7 · MP1060.x
MP1060.x represents the smallest acceleration in the working plane.
7
77
7 At mid-range feed rate (approx. 500 mm/min) check the parameter MP2610.
At the optimum setting the reversal peaks are at a minimum.
At feed rates greater than approx. 6000 rpm the reversal peaks might point
inward as a result of overcompensation:
7
77
7 In this case, increase MP2612.x until the reversal peaks no longer point
inward.
To Next Page
Loading...
