HEIDENHAIN TNC 430 PA - File Management Differences from File Management of NC Part Programs

7 – 6 HEIDENHAIN Technical Manual TNC 426, TNC 430
7.1.3 File Management
File management in PLC mode is largely the same as in the Programming and
Editing mode of operation (see User's Manual for TNC 426/TNC 430). If in PLC
mode you press the PGM MGT key, the TNC displays the TNC partition as well
as the PLC partitions at the upper left of the screen.
Differences from
file management of
NC part programs
The following are file types displayed by the TNC when you press the FILE
TYPE soft key:
With the MORE FUNCTIONS soft key you select the following functions:
Soft key Function
Show all files.
Show only PLC programs (*.PLC).
Show only ASCII files (*.A).
Show only help files (*.HLP).
Show only system files (*.SYS).
Show only compensation value tables (*.COM).
Show only tables with compensation value assignments
(*.CMA).
Show only tables with PLC error messages (*.PET).
Back to previous menu.
Soft key Function
Generates a list of cross references. You cannot use a file
name extension already used by the TNC (. PLC, .CMA etc.).
Generates a list of programs, numbered by line.
Generates a program list and cross reference list, numbered
by line.