HEIDENHAIN TNC 430 PA - Overview of Markers and Words

5 – 10 HEIDENHAIN Technical Manual TNC 426, TNC 430
5.2 Overview of Markers and Words
Marker Description Set Reset SW Vers. Page
M 1900 -
1999
Decoded M function if M4571 is set NC NC 6 – 283
M 4000 Spindle in position NC NC 6 – 203
M 4001 Nominal speed command signal of the
spindle not in the ramp
NC NC 6 – 186
M 4002 Nominal speed value = 0 NC NC 6 – 186
M 4003 Nominal speed value output analog or digital
(MP3010 = 3 to 8)
NC NC 6 – 184
M 4004 Impermissible speed was programmed NC NC 6 – 187
M 4005 Status display and nominal speed value
output for M03
PLC PLC 6 – 186,
6 – 238
M 4006 Status display and nominal speed value
output for M04
PLC PLC 6 – 186,
6 – 238
M 4007 Status display M05 and spindle stop PLC PLC 6 – 186,
6 – 238
M 4008 Disable speed output for spindle PLC PLC 6 – 187,
6 – 238
M 4009 Counterclockwise spindle rotation (for gear
change)
PLC PLC 6 – 189
M 4010 Clockwise spindle rotation
(for gear change)
PLC PLC 6 – 189
M 4011 Activate rotational speed MP3520.0 and
direction of rotation from M4013
PLC PLC 6 – 205
M 4012 Opening the spindle control loop PLC PLC 6 – 203,
6 – 352
M 4013 Direction for spindle orientation from a
standstill (M03 = 0; M04 = 1)
PLC PLC 6 – 205
M 4014 Reverse the direction of spindle rotation PLC PLC 6 – 186
M 4015 Renewed evaluation of the spindle
reference mark
PLC NC 6 – 203
M 4016 Cycle 13 is executed NC PLC 6 – 205
M 4017 Spindle moving in feedback control NC NC 6 – 203
M 4018 Reference mark for spindle not yet
traversed
NC NC 6 – 203
M 4019 Reversing the counting direction of the
position encoder on the spindle
PLC PLC 6 – 186
M 4030 Cycle 2 or Cycle 17 active NC NC 6 – 207,
6 – 211
M 4031 Cycle 17 or Cycle 18 active NC NC 6 – 211