HEIDENHAIN TNC 430 PA - Page 334

6 – 4 HEIDENHAIN Technical Manual TNC 426, TNC 430
6.23 Integrated Oscilloscope............................................................. 6 – 457
6.24 Commissioning .......................................................................... 6 – 462
6.24.1 Preparation .......................................................................... 6 – 462
6.24.2 Digital Axes ......................................................................... 6 – 462
6.24.3 Analog Axes ........................................................................ 6 – 502
6.24.4 Digital Spindle for TNC 426 without Spindle DSP ............... 6 – 506
6.24.5 Digital Spindle for TNC 430 / TNC 426 with Spindle DSP ... 6 – 512
6.24.6 Analog Spindles ................................................................... 6 – 517
6.25 Block Diagram TNC 426, TNC 430 ............................................ 6 – 519