6 – 82 HEIDENHAIN Technical Manual TNC 426, TNC 430
MP7510 Transformed axis
Format: %xxxxxx
Input: 0: End of the transformation sequence
Bit 0 corresponds to axis X
Bit 1 corresponds to axis Y
Bit 2 corresponds to axis Z
Bit 3 corresponds to axis A
Bit 4 corresponds to axis B
Bit 5 corresponds to axis C
MP7510.0–14Transformation 1 to transformation 15
MP7520 Additional code for transformation
Format: %xx
Input: Bit 0 – Tilting axis
0: Swivel head
1: Tilting table
Bit 1 – Type of dimension in MP7530
0: Incremental dimension for swivel head
1: Absolute with respect to the machine datum for tilting table
MP7520.0–14Transformation 1 to transformation 15
MP7530 Type of dimension for transformation
Input: -99 999.9999 to +99 999.9999
0: Free tilting axis
MP7530.0–14Transformation 1 to transformation 15
MP7550 Home position of the tilting element
Input: -99 999.9999 to +99 999.9999
MP7550.0 A axis
MP7550.1 B axis
MP7550.2 C axis
MP7682 Machine parameter with multiple function
Format: %xxx
Input: Bit 1 – Reference value for calculating the preset during “datum
setting”
0: Actual value is calculated
1: Nominal value is calculated
Note
MP7530 cannot be overwritten with Module 9031 (overwrite machine
parameters), since the MP contains a string, but the module transfers an
integer value.
To Next Page
Loading...
