HEIDENHAIN TNC 430 PA - Page 588

6 – 258 HEIDENHAIN Technical Manual TNC 426, TNC 430
Settings for simulation
SIMU.ENAPRESET String Preset enable
SIMU.ENALIMIT String Limit switch enable
SIMU.LIMITPL [5] Double Positive limit switch
SIMU.LIMITMI [5] Double Negative limit switch
SIMU.PRESET [5] Double Preset values
Settings of the machine
MACHINE.LIMIT1PL [5] Double Pos. limit switch group 1
MACHINE.LIMIT1MI [5] Double Neg. limit switch group 1
MACHINE.LIMIT2PL [5] Double Pos. limit switch group 2
MACHINE.LIMIT2MI [5] Double Neg. limit switch group 2
MACHINE.LIMIT3PL [5] Double Pos. limit switch group 3
MACHINE.LIMIT3MI [5] Double Neg. limit switch group 3
MACHINE.PRESET1 [5] Double Preset values 1
MACHINE.PRESET2 [5] Double Preset values 2
MACHINE.PRESET3 [5] Double Preset values 3
MACHINE.POSINC [5] Double
MACHINE.DRVOFFSET [5] Double
MACHINE.HANDW_FACTOR [5] Double Handwheel interp. factor
Settings for transformation of the machine reference system
MATRANS.PRESX1_ABC [3] Double
MATRANS.PRESY1_ABC [3] Double
MATRANS.PRESZ1_ABC [3] Double
MATRANS.PRESAXIS1 String
MATRANS.PRESX2_ABC [3] Double
MATRANS.PRESY2_ABC [3] Double
MATRANS.PRESZ2_ABC [3] Double
MATRANS.PRESAXIS3 String
MATRANS.PRESZ3_ABC [3] Double
MATRANS.TRLPRES1 [6] Double
MATRANS.TRLPRES2 [6] Double
MATRANS.TRLPRES2 [6] Double
MATRANS.TRLPRES3 [6] Double
MATRANS.MANUAL String
MATRANS.PGRMRUN String
MATRANS.ANGLE [3] Double