December 2001 Display and Operation 6 – 281
M89 Vacant miscellaneous function or cycle call, modally effective
b
E
M90 Operation with following error: Constant feed rate in corners A
M91 Within the positioning block: Coordinates are referenced to machine
datum
A
M92 Within the positioning block: Coordinates are referenced to a position
defined by the machine tool builder, such as tool change position
A
M93 A
M94 Reduce the rotary axis display to a value below 360° A
M95 - M96 Approach behavior at the starting point of the contour E
M 97 Machine small contour steps E
M 98 Machine open contours completely E
M 99 Blockwise cycle call E
M100 E
M101 Automatic tool change with replacement tool if maximum tool life
has expired
A
M102 Reset M101 E
M103 Reduce feed rate during plunging to factor F A
M104 Reactivate most recently defined datum A
M105 Machine with second k
V
factor A
M106 Machine with first k
V
factor A
M107 Suppress error message for replacement tools A
M108 Reset M107 E
M109 Constant contouring speed on the tool cutting edge (increasing and
decreasing the feed rate)
A
M110 Constant contouring speed on the tool cutting edge (only decreasing
the feed rate)
A
M111 Reset M109/M110 E
M112 Insert rounding radius between nontangential straight lines A
M113 Reset M112 E
M114 Automatic correction of machine geometry when working with tilting
axes
A
M115 Reset M114 E
M116 Feed rate for rotary axes in mm/min A
M117 Reset M116 E
M118 Superimpose handwheel positioning during program run A
M119
M120 LOOK AHEAD: Calculate the radius-compensated tool path ahead of
time
A
M121 - M123
M functions Meaning Effectiveness
To Next Page
Loading...
