6 – 314 HEIDENHAIN Technical Manual TNC 426, TNC 430
Module 9256 Writing to a field in a table
Open the table with the file name extension .TAB or .P with Module 9240, and
not in the “buffered” mode.
The field defined by the column name and line number is overwritten.
This module can be used only for an integer. Values with decimal places are
written without the decimal point.
Call:
PS D <File handle>
from Module 9240
PS B/W/D/K <Line>
0 to 65 535
PS B/W/D/K/S<String number, column name>
0 to 15
PS B/W/D/K <Numerical value to be written>
CM 9256
Error recognition:
Marker Value Meaning
M4203 0 Field was written to
1 Error code in W1022
W1022 See Module 9246
To Next Page
Loading...
