December 2001 Tool Changer 6 – 403
MP7266.10 Maximum tool age TOOL CALL TIME2 5
MP7266.11 Current tool age CUR.TIME 8
MP7266.12 Comment on the tool DOC 16
MP7266.13 Number of tool teeth CUT 4
MP7266.14 Wear tolerance for tool length LTOL 6
MP7266.15 Wear tolerance for tool radius RTOL 6
MP7266.16 Cutting direction of the tool DIRECT 7
MP7266.17 Additional information for PLC
(Module 9093)
PLC 9
MP7266.18 Tool offset: length TT: LOFFS 11
MP7266.19 Tool offset: radius TT: ROFFS 11
MP7266.20 Breakage tolerance for tool
length
LBREAK 6
MP7266.21 Breakage tolerance for tool
radius
RBREAK 6
MP7266.22 Tooth length LCUTS 11
MP7266.23 Plunge angle ANGLE 7
MP7266.24
a
Tool type (MILL=cutter/
DRILL=drill)
TYPE 5
MP7266.25
a
Tool material TMAT 16
MP7266.26
a
Cutting data table CDT 16
MP7266.27
b
PLC value PLC-VAL 11
MP7266.28
c
Center misalignment in
reference axis
CAL-OF1 11
MP7266.29
c
Center misalignment in minor
axis
CAL-OF2 11
MP7266.30
c
Spindle angle during calibration CAL-ANG 8
a. As of NC software 280 472-01
b. As of NC software 280 474-05
c. As of NC software 280 476-01
MP Meaning Column name Column
width
To Next Page
Loading...
