December 2001 Tool Changer 6 – 425
You define a fixed pocket with the “F” field. If a fixed pocket has been defined
for a tool, it will be returned to its original pocket in spite of the variable pocket
coding.
Set Reset
M4520 Another T code (P code) follows with
TOOL CALL
0: A normal tool follows a normal tool (N → N)
Manual tool follows a manual tool (M → M)
Special tool follows a special tool (S → S),
when M4541 = 0
1: Special tool follows a manual tool (M → S),
if M4541 = 1
Special tool follows a special tool (S → S),
when M4541 = 1
Manual tool follows a special tool (S → M)
Manual tool follows a normal tool (N → M)
Normal tool follows a manual tool (M → N)
Normal tool follows a special tool (S → N)
See M4540.
NC NC
M4522 Tool programmed with pocket number if
MP7480.0 = 3 or 4 and TOOL CALL
NC NC
M4523 Tool programmed without pocket
number is effective if
MP7480.0 = 3 or 4 and TOOL CALL
NC NC
M4524 Special tool called, TOOL CALL NC NC
M4525 TOOL CALL after expiration of tool life
1: TOOL CALL after expiration of tool life
NC NC
M4540 Sequence of tool number or pocket
number transfer (M4520 = 1)
n 0: First the number for the old tool, then the
number for the new tool (single changing
arm)
n 1: First the number for the new tool, then
the number for the old tool (double
changing arm)
PLC PLC
M4541 Special tool in original pocket in spite of
variable pocket coding
PLC PLC
M4542 Do not update pocket number in pocket
table
PLC PLC
To Next Page
Loading...
