December 2001 Software Releases 2 – 69
NC Software
280 476-10 (export
version 280 477-10)
Release: 06/00
n MP6165: New probing function for the TS 632
n New password AXISNUMBER for OEM.SYS, to limit the number of
machine parameter indexes
NC software
280 476-11 (export
version 280 477-11)
Release: 07/00
n MP1087.x: Axis-specific jerk for Manual mode
n MP7680 bit 12: Behavior of Cycle 28
n New error message for FN14
n FN17 ID990: Axis shown on top of other axis due to tilting motion?
NC software
280 476-12 (export
version 280 477-12)
Release: 07/00
NC software
280 476-13 (export
version 280 477-13)
Release: 10/00
n MP110.x and MP111.x no longer result in a RESET
n Maximum input ranges for MP2391.x, MP2393.x, MP2395.x, MP2500.x,
MP2501.x, MP2510.x and MP2511.x, MP6160, MP6161, MP6560, MP7442
expanded
n MP7500 bit 8: Recalculate the datum to the home position of the tilting
element
n EnDat multiturn encoders as position encoders
n Actual-to-nominal value transfer only occurs in the affected axis during an
erasable positioning error
n New function: Field orientation for synchronous spindles with encoders
without a Z1 track, or nonaligned encoders with EnDat interface
n New motor table motor.mot
n FN18 ID290: Determine the value of the bits in MP7500
n Module 9146: Saving and reestablishing actual position values
n Module 9147: Bit from W1032 is reset
n Module 9157: Drive controller status
n Behavior during calibration of the touch-trigger probe with infrared
transmission changed
n Tool-by-tool execution of pallet tables
n Cycle 431: Establish spatial angle
n Cycle 247: Set a datum from a datum table as the datum in the REF system
NC software
280 476-14 (export
version 280 477-14)
Release: 11/00
n FN18 ID214: Ascertain tolerance in Cycle 32 or MP1096
To Next Page
Loading...
