December 2001 Data Transfer NC → PLC, PLC → NC 7 – 33
Write values from active pallet table
510 1 – Active lines
2 – Pallet number from column Name
3 – Active line of the pallet table
4 – Last line of the NC program of the
current pallet
5 1 to 9 Tool-oriented machining
0 = Safety height not programmed
1 = Safety height programmed
6 1 to 9 Programmed safety height in a pallet
table for tool-oriented machining
Touch probe cycles
990 1 – Approach behavior
0 = Standard behavior
1 = Effective radius, safety clearance
zero
2 10 0.0 = Execution not in block scan
1.0 = Execution in block scan
–1.0 = Invalid index
16 0.0 = Execution not in Automatic
operating mode
1.0 = Execution in Automatic
operating mode
–1.0 = Invalid index
Coordinate transformation
3 No. of the 1st of
9 consecutive Q
parameters for
axes X, Y, Z, A,
B, C, U, V, W
Number of axes that are programmed
in the selected datum table
8 – Current spindle angle
Group
name
Group
number
ID....
System data
number
NR....
System data
index
IDX....
System data item
To Next Page
Loading...
