Start-Up
12
Start-Up
Setting up device
Before start-up the device has to be mounted by aid of the support rod either to a stand
or to a wall grid (see chapter “Assembly, Support rod and quick chuck”, section “Mounting
the support rod”).
Warning:
Risk of device slipping
Due to vibrations during operation the device may start moving over
the surface and may fall o, if mounted to a stand.
The surface must be smooth and clean and should be completely level.
Warning:
Possible detachment of the device!
Due to vibrations during operation the clamping screws may loosen,
which tighten the device to the stand or to the wall grid.
Tighten the clamping screws carefully. Check the safe xing in regular
intervalls.
Connecting/disconnecting the power
supply cable
Connecting the power supply cable
The device is supplied with a three-pole
power supply cable which features a
safety clip to hold the female connector in
position.
Female
connector
Power supply
cable
Safety
clip
✓ The device is switched o.
➜ Connect the female connector of the
power supply cable to the device
connector.
✓ The female connector is securely
engaged when a click is heard.
➜ Insert the male connector of the
power supply cable into the mains
socket-outlet.
Device connector
To Next Page
Loading...
Need help?
General
