Heidolph Hei-VAP Value - Disconnecting the Coolant; Vacuum; Remove the Heating Bath; Storage; Disposal

Dismantling, storage, disposal
62 Hei-VAP Value, Hei-VAP Advantage
EN
EN
10.1.2 Disconnecting the coolant / vacuum
1. Verify that the coolant and vacuum supply is switched off and that the system is at
atmospheric pressure.
2. Disconnect the tubes from the condenser and drain coolant safely into a storage
container.
10.1.3 Remove the heating bath
WARNING
Hot surfaces!
Scalding and burns.
 Cool the heating bath.
 Remove the heating bath in reverse sequence of the assembly (see chapter 4.4.1).
10.2 Storage
Evaporator
 The unit may be stored in a dry location.
 Store the unit in the original packaging (only possible with the transportation protec-
tion device attached).
 Close the packaging with adhesive tape.
Glassware set
 The glassware set may be stored in a dry location.
 Empty and clean the glassware set.
 Store the glassware set in the original packaging.
 Close the packaging with adhesive tape.
10.3 Disposal
 Properly dispose of the unit according to the valid national and legal regulations
pertaining to disposal of used laboratory equipment.
Coolant /
vacuum
Remove the heat-
ing bath
Where?
How?
Where?
How?
Disposal