Users Manual Henkovac 04-serie V2019
2. Save the new value by pressing the menu button
3. To retain the original value, press the button
4. Exit the program by pressing the menu button
7.1.6 Turning Off Machine
1. Turn the machine off by pressing the button
2. The symbol on the display will start blinking
3. Push the button a second time and the pump will stop immediately
4. If no action is taken the pump turns off after 4 seconds
5. Close the cover and the machine will initiate the cool-down phase and
perform a number of vacuum cycles while the cover stays closed and
the machine will turn off automatically after about 15 minutes
These cycles are necessary to cool down the machine and to allow
any moisture in the oil of the pump to evaporate
7.2 Ten-Program Control System
The Ten-Program control system is standard time-based on the
M2, M4-M8, D1-D6
sensor-based operation is an option, which can be installed at a later date
The Ten-Program control system provides:
1. 9 customizable programs (P1-P9)
2. Program PA; this is an - Automatic Program –
Pre-set at the factory at a vacuum time of 30-40 seconds
(or 5 mbar for a sensor-based program) and a sealing time
of 2 seconds
3. Program P H
2
O for liquid products (see page 19)
When turning on the machine, the pump will start. After about
15 minutes of inactivity, the pump will stop automatically
7.2.1 Programmable Functions
The following functions may be customized for each program P1-P9:
Vacuum time: in seconds or mbar (only with sensor)
Sealing time: in seconds
Vacuum Plus: on/off, in seconds
Gassing: on/off, in seconds or mbar (only with sensor)
Clean Cut Controlled (CCC) Seal: on/off, in seconds
Soft-Air: on/off, in seconds or mbar (only with sensor)
Multi-cycle: on/off, in number of cycles
To Next Page
Loading...
