15
Joysticks - Standard GR joysticks provide stepless
proportional speed control without detents. Optional
joysticks have five-stop speed control with detents.
NOTE: GR transmitters for 5, 6, 7, and 9 motions use
two or three joysticks and a three-position Selector
toggle switch.
Paddle Levers - Standard GR paddle levers provide
stepless proportional speed control without detents for
up to 7 motions.
Option Toggle Switch - The connected function will be
activated when the toggle switch is moved to the ON
position. The function will stop when the switch is
moved to the OFF position.
Selector Toggle Switch - This three-position switch
allows the operator to control multiple cranes/machines
from a single transmitter, or multiple crane/machine
motions from a single joystick or paddle lever. The
selections can be A, B, or A+B.
FREQUENCY AND ADDRESS SETTINGS
Each Hetronic radio remote control system contains a
radio frequency (RF) unit. Each system consists of a
transmitter RF unit and a receiver RF unit.
The address settings are pre-set at the factory in the
ADMO module. However, if the transmitter coder
board, the base board, or if the entire transmitter or
receiver are replaced, the ADMO address must match
the system.
IMPORTANT: If the ADMO settings of the transmitter
and receiver do not match, the system will not function.
CAUTION: AVOID INJURY OR DAMAGE -
Operating the transmitter without its antenna
could destroy the final stage of the RF
module. DO NOT attempt to change the
Hetronic pre-set frequency or the 16-bit
address. Personal injury and property
damage could result from transmission
interference and may void the warranty.
To Next Page
Loading...
