Hettich EBA 20S - Error Message Diagnostics; MAINS RESET Procedure; Error Code Quick Reference

10/34
5 Error messages
The error message will be indicated in the speed display of the front panel
e.g. :
RPM x 100
t
START
STOP
5.1 MAINS RESET
• Switch off the mains switch.
• Wait at least for 10 seconds and then switch on the mains switch again.
5.2 Brief description
Display. Fault Brief description Page
- 1 - Tacho error Tacho pulses break down during the run 11
- 2 - System reset Mains interrupt 11
- 3 - Imbalance Imbalance on the motor axis 11
- 4 - Communication Communication error 12
- 5 - Overload Fault in the motor or the motor control 12
- 6 - Overvoltage Mains is out of the tolerance 13
- 7 - Overspeed Overspeed detected 13
- 8 - Undervoltage Mains is out of the tolerance 13
- 9 - Overtemperature Overtemperature switch in the motor release 14
Versions Error No indication in the speed display
Wrong machine version setting
16
- c - Controller-Watchdog Fault in power board 14
- d - Lid lock error Fault in lid lock system 15
- E - Short circuit Short circuit in power board 15
- F - No Rotor code Wrong machine version 15