CP : control panel, FC : frequency converter, SB : supply board, CB : cooling board, CC : control cable, LL : lid locking, BC : braking chopper,
BR : brake resistor, MR : mains reset, EC : error cause, ES : error consequence, ER : error remedy, M : measurements, ECR : error-code reset
14/51
Error designation No. Brief description Page
No cooling
(No error displayed)
Overtemperature at condenser 19
°C / *-ERROR
52 Overtemperature in centrifuge chamber 20
°C / *-ERROR 53 Temperature sensor in centrifuge chamber is
defective
20
FU/CCI-ERROR 60 Faulty release signal to FC 20
FU/CCI-ERROR 61 FC - error: computing section 21
FU/CCI-ERROR 62 FC - error: undervoltage 21
FU/CCI-ERROR 63 FC - error: overcurrent 21
FU/CCI-ERROR 64 FC - error: overvoltage 21
FU/CCI-ERROR 67 FC - error: overtemperature in motor
(only 115V)
22
FU/CCI-ERROR 68 FC - error: overtemperature in FC 22
FU/CCI-ERROR 69 FC - error: EEPROM 22
FU/CCI-ERROR 84 FC - error: FC recognizes excess speed 22
FU/CCI-ERROR 85 FC - error: “Watchdog”in FC had
Triggered
22
To Next Page
Loading...
Need help?
General
