Hexagon GLOBAL S - Page 21

Overview • 21
Slow
The button is used to set the machine axis maximum speed when movement is controlled
by Jogbox. Two values can be selected (fastJogVel and slowJogVel, with
fastJogVel>slowJogVel). These are configured in the control system.
When the control system is in Manual status, the maximum speed of the machine axes
is set to the lower of the values between the one set using the SLOW pushbutton and the
manualVel setup parameter. (The manualVel setup parameter specifies the maximum
speed at which the linear axes of the measuring machine can be moved using the joystick
or the Part Program when the control system is in Manual status).
The LED shows the current setting:
 LED off. The set speed is fastJogVel. (or manualVel as described above).
 LED on. The set speed is slowJogVel. Default setting at control system start-up
(or manualVel as described above).
Important Note: The measuring performance and operation of the measuring machine
in use is only guaranteed if the maximum speed is set to slowJogVel (and the PROBE
ENABLE LED is on). When the axes are moved using the joystick with fastJogVel (LED
off), to prevent problems caused by false triggering, we recommend you select “LED off”
status on the PROBE ENABLE button.
Delete point
The button is used to eliminate the last measured point. Press in sequence to eliminate
a point of the last measured series.
Done
This button is used to reply to requests from the software
Move point
The button is used to register positioning and release points.
X, Y, Z
Each of these three buttons enables or disables the movement of the corresponding axis
using the Jogbox.
The LED shows the current setting:
 LED off. The axis cannot be moved.
 LED on. The corresponding axis can be moved.
Shift
This button is used to select the reference axis triad.
 LED off. The main triad is selected (machine).
 LED on. The secondary triad is selected (e.g. wrist).