GLOBAL S - User Manual
Eco Mode +
Enable/disable supplementary Eco Mode + energy saving mode to reduce compressed air consumption.
When enabled, this mode automatically cuts off the air flow to the air bearings after a given period of time
of non-use of the machine, thus reducing energy consumption and processing costs. The interval of time
before the Eco Mode + starts working can be set by the user by means of the “Time” control on the
FDCPanel, to a minimum of 10 minutes.
Note on Eco Mode + operation:
The Eco Mode + function is only available when the Eco Mode function is enabled.
Start and permanence of the machine in the Eco Mode + condition are indicated by the JogBox by
the alternating blinking of the LEDs of the “DONE” (1) and “MOVE POINT” (2) buttons at a lower
frequency than that already used to indicate the Eco Mode condition.
The air flow to the air bearings is automatically reactivated without any intervention by the operator
as soon as a movement must be performed (by means of the JogBox or part program).
The Eco Mode + function also works when the machine is in emergency stop conditions. In this
case, the air flow to the air bearings is reactivated when the machine start button is pressed.
In all cases, when the air flow is reactivated the machine remains in a waiting state for a given time
(1-2 seconds) in order to allow the pressure to stabilise in the pneumatic circuit.
Auto retract
Enables/disables automatic movement performed after taking a point in jog mode. This automatic
movement, if enabled, moves the probe away from the part to the distance set in the “Distance” field.
To Next Page
Loading...
