47
7. Safety instruction when operating
z Press the clutch pedal fully and then engage or disengage the
PTO
z When cold weather, please warm up the operating oil for 10 -
15 minutes
z Operate the crane on even ground condition
z Before operating the hook, turn on the overwinding alarm
switch
z Be careful not to touch the hook block on the ground, which
could cause the wire to get tangled
z Do not drag the load using the crane which may cause
damage to the crane
z Do not exceed the lifting capacity shown in the load table
z Slew as slow as possible
z When load and unload in underground, check the remaining
wire length on the winch drum. Minimum 3 turns.
z Do not leave from the operating position when load is
suspended
z Do not be allowed that unauthorized persons is in the working
area
z Make sure that the hook is firmly fixed and the PTO
disconnected before driving
z You should consult your dealer and/or trained person if you
find some problems
To Next Page
Loading...
