To Next Page

To Previous Page

DTC1000/1000M/4000/4500 Ethernet User Guide – Installation Guide L001411

(Rev.1.1)

 The current settings will be Dynamic only if Obtain an IP address automatically

was selected when the Printer was restarted last.

Switching to the automatic IP address mode

Step

Procedure

Select the Network link from any web page of the Printer.

Select the Obtain an IP address automatically radio button to enable the

DHCP/BOOTP, which automatically assigns the network settings.

Even with this button selected, the User can enter Stored Settings, and the

Stored Settings will remain in memory. See below. (Note: This is the

default method.)

Click on the Submit button to save this setting.

setting will only be accepted after you have successfully logged in.)

Reboot the Printer for this change to take effect.

Changing to the static IP address mode

Step

Procedure

Select the Network link from any web page of the Printer.

Select the Use the following IP address radio button, which prepares the

Printer to use network settings that the User has manually set.

These manual settings will then be used the next time the Printer is

rebooted.

Enter the network settings which are required for Ethernet communications

from within the same subnet.

With only these entries the User will be unable to print from a subnet other

than the subnet on which the Printer is connected. These required settings

are the following:

 IP Address

 Subnet Mask

Questions and Answers:

Need help?

Do you have a question about the HID DTC4000 and is the answer not in the manual?

HID DTC4000 Specifications

General