Printer settings
Setting Description
Head Resistance This is factory set. If the main board or the printhead is replaced, then adjust this number. Locate the
printhead setting number on the bottom of the printhead. The number reads: R=XXXX.
Print Left Of Form Prints the alignment self-test card.
Adjust the Print Left of Form up or down until the border of the left of form zero line is showing on the edge of
the card.
Measure the density square. Adjust the image density to 65% ± 1%.
Image Darkness Use this option to set the overall darkness of the printed image by increasing or decreasing the amount of
heat the printhead uses while printing.
Use the up and down arrows to increase or decrease the amount of heat.
Important: If the value is set too high, the ribbon may jam or break.
PLT-02931, A.4 76 November 2021
Powering
Trusted Identities
FARGO® HDP®6600 High Definition Card Printer/Encoder
User Guide
To Next Page
Loading...
