12 January 2019
Module description PLT-01628, Rev. D.2
3.3.2 PAM operation with Card Passthrough
When Card Passthrough is enabled, the PAM will direct the reader to perform an autonomous poll and
process using a scan and process command. This can be sent at any point after receiving the response from
the previous command to the reader. Current implementation has it after the HF poll.
Example process of PAM with Card Passthrough enabled:
1. Scan for PIV or like card
2. Get Response
3. Send Scan and process command
4. Get response
5. Scan for contact card
6. Get response
7. Disconnect (this step may not be needed)
8. Get response
9. Start over
To Next Page
Loading...
