Handheld Thermal Monocular Camera User Manual
18
10. Hold the wheel to exit the interface according to the prompt.
– OK: Save the parameter and exit.
– CANCEL: Exit but not save the parameters.
Note
● 5 types of reticles can be selected.
● When you switch the reticle No., a prompt will appear on the interface. Select OK to save the
parameters for the current reticle.
● If the PIP function is enabled, the aimed target can be magnified on the interface.
Figure 6-1 PIP Effect in Correcting Reticle
6.2 Set Reticle Color
The function can change the color of the reticle in reticle correction display and distance
measurement display.
Before You Start
Enable reticle correction first.
To Next Page
Loading...
