HikRobot ID6000 Series - Chapter 4 Installation; 4.1 Installation Preparation; 4.2 Install Device

ID6000 Series Smart Code Reader User Manual
10
Chapter 4 Installation
4.1 Installation Preparation
You need to prepare following accessories before installation.
Table 4-1 Accessories
No.
Name
Quantity
Description
1
Power and I/O
Cable
1
It refers to the 12-pin power and I/O cable. You
need to purchase separately.
2
Network Cable
1
It refers to the GigE network cable with RJ45
aviation connector. You need to purchase
separately.
3
DC Switch
Power Supply
1
It refers to suitable power adapter that you need
to purchase it separately.
4
Fixed Bracket
1
It is used to fix the device. You need to purchase
separately.
5
Lens
1
It refers to C-mount lens that you need to
purchase it separately.
6
Light Source
1
It is used to provide light during image acquisition.
You need to purchase separately.
4.2 Install Device
Before You Start
● Make sure the device in the package is in good condition and all the assembly parts are
included.
● Make sure all the related equipment is power-off during the installation.
Steps
Note
Here we take type I device as an example to introduce installation.
1. Use 4 M4 screws to fix the device to the bracket, and select one of installation methods to
install the device to the installation position.