ID6000 Series Smart Code Reader User Manual
16
1) Go to NIC settings page: Control Panel → Hardware and Sound → Device Manager →
Network Adapter.
2) Select corresponding network interface card, and click Advanced.
3) Set Jumbo Packet value to 9014 Bytes, Transmit Buffers and Receive Buffers to 2048,
Interrupt Moderation Rate to Extremum.
Note
The value may vary from different network interface cards. Just set the maximum value if
value changes.
Figure 5-2 NIC Properties Advanced Settings
5.2 Set Device Network
You can set and operate the device in the client software only when the device is in the same
network segment with the PC where the client software is installed.
Steps
1. Double click the client software to run it.
2. Click to find the device.
3. Right click the device to be connected.
4. Click Modify IP.
5. Set the IP address of the device in the same network segment with the PC.
To Next Page
Loading...
