ID6000 Series Smart Code Reader User Manual
34
Figure 7-15 Set and Execute UDP Trigger Mode
Set and Execute Serial Port Trigger Mode
Serial start specifies the serial port as the source for the trigger signal. When the serial port
receives the specified string text, the trigger signal will be outputted.
Click I/O Control Settings → Input → Trigger Mode, select On as Trigger Mode and select Serial
Start as Trigger Source.
Set Trigger Delay, Serial Baudrate, Serial Data Bits, Serial Parity, Serial Stop Bits, and Serial Start
Trigger Text according to actual demands.
Figure 7-16 Set and Execute Serial Port Trigger Mode
7.5.4 Stop Trigger
The device supports stopping trigger via TCP, UDP, I/O, and serial port. You can also set code
To Next Page
Loading...
