AX PRO User Manual
25
The device will push notifications when panic alarm is triggered or restored by zones, keypads
or keyfobs.
Medical Alarm Notification
The device will push notifications when medical alarm is triggered.
Gas Alarm Notification
The device will push notifications when gas alarm is triggered.
Fire Alarm Notification
The device will push notifications when fire alarm is triggered or a user presses the fire alarm
key on the keypad.
AX PRO System Status Notification
The device will push notifications when the AX PRO system status is changed.
Wireless Detector Status Notification
The device will push notifications when any wireless detector status is changed.
Device Status Notification
The device will push notifications when any device status is changed.
Alarm Center
You can set the alarm center's parameters and all alarms will be sent to the configured alarm
center.
Steps
1. In the site, tap the AX PRO and then log in to the device (if required).
2. Tap → Communication → Alarm Center to enter the page.
3. Select an alarm center and enable it.
4. Select the Protocol Type as ADM-CID, ISUP, SIA-DCS, *SIA-DCS, or *ADM-CID to set uploading
mode.
ADM-CID or SIA-DCSYou should select the Alarm Receiver Type as IP or Domain name, and
enter the IP/domain name, port number, account code, timeout, re-upload times and
heartbeat interval.
Note
Set the heartbeat interval with the range from 10 to 3888000 seconds.
ISUPYou do not need to set the ISUP protocol parameters.
*SIA-DCS or *ADM-CIDYou should select the Alarm Receiver Type as IP or Domain name,
and enter the IP/domain name, port number, account code, retry timeout period , attempts,
heartbeat interval, encryption arithmetic, password length and secret key.
To Next Page
Loading...
Need help?
General
