23
Configure Date & Time:
Steps:
1. Click the Date & Time button on the right of the General interface to enter the configuration interface.
Figure 3.11 Date and Time Configuration Interface
2. Set the date and time in two ways.
Task 1: Automatic mode
Steps:
Enable the automatic mode by switching to , or else the manual mode is enabled.
Task 2: Manual mode
Steps:
1) Click to set the current date as shown in Figure 3.12.
2) Click to set the current time as shown in Figure 3.12.
Figure 3.12 Date and Time Configuration
Select Time Zone:
Steps:
Click to select time zone in your location. The pop-up interface is shown in Figure 3.13.
To Next Page
Loading...
