68
2. Click Delete to confirm the deletion.
3. (Optional) You can click to cancel the deletion.
Editing the User Accounts by the Operator
Steps:
1. Click the user account on the User Management interface for the operator. The Set Password dialog box
pops up as shown in Figure 4.70.
Figure 4.70 Editing the User Account by the Operator
2. You can change the old password by entering the Old Password, New Password and confirming the password.
3. Click to confirm the editing.
4. (Optional) You can click to cancel the editing.
Logout
Admin Logout
Steps:
1. Click on the upper-right corner of the User Management interface for the admin to logout.
Figure 4.71 Logout Interface for the Admin
2. Click Confirm to logout.
3. (Optional) Click to cancel the operation.
Operator Logout
This section takes example of the operator account of user01.
Steps: