User Manual of Network Camera
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
Figure 6-31 Alarm Output Settings
6.6.5 Handling Exception
The exception type can be HDD full, HDD error, network disconnected, IP address
conflicted and illegal login to the cameras.
Steps:
1. Enter the Exception Settings interface:
Configuration > Advanced Configuration> Events > Exception
2. Check the checkbox to set the actions taken for the Exception alarm. Refer to
Step 3 Set the Alarm Actions Taken for Motion Detection in Section 6.6.1.
Figure 6-32 Exception Settings
3. Click to save the settings.
To Next Page
Loading...
