Installation Manual of Network Camera
Figure 3-13 Overview
Table 3-3 Description
10M/100M self-adaptive Ethernet interface
INITIAL SET: Reset button
AUDIO OUT: Audio output interface
MIC IN: Audio input interface
1A, 1B, 2A, 2B: Alarm output interface
IN1, GND, IN2, GND: Alarm input interface
Note: To reset the default parameters to the camera, you need to press and hold the RESET button
and power on the camera. After the power on of the camera, you must still press and hold the
Reset button for about 20 seconds
Camera wiring Diagram:
To Next Page
Loading...
