Installation Manual of Network Camera
Chapter 6 Mini Dome Camera Installation
6.1 Appearance Description
Camera description:
Figure 6-1 Overview
Table 6-1 Description
P: Power LED indicator, It is solid red when power is applied to the unit.
S & L: Network status LED indicator.
When the network is connected, the “S” LED is solid yellow, while the “L” LED
flashes orange.
Note:
To reset the default parameters to the camera, you need to press and hold the RESET button and
power on the camera. After the power on of the camera, you must still press and hold the Reset
button for about 20 seconds
Camera wiring Diagram:
To Next Page
Loading...
