HIKVISION DS-2SE7C43C432MW-AEB

Steps
1.
Go to Conguraon → PTZ → Posion Sengs .
2.
Manually set device direcon by selecng the PT Mode as Manual.
1) Adjust the
lt posion of the device to 0 by controling the up arrow and down arrow on the
PTZ panel.
2) Adjust the pan posion to show the live view of the north direcon by controling the le
arrow and right arrow on the PTZ panel.
3) Click Set as North.
3.
Input the longitude and
latude of the device manually.
4.
Click Save.
What to do next
If you lost
direcon when operang the device, you can click Point to North to call the north
posion that is saved in the device.
4.14 Panorama Tracking
This funcon links panoramic channel with PTZ channel through calibraon. The PTZ channel tracks
moving objects in panoramic channel and
automacally adjusts its PTZ posions to keep the target
in the center of PTZ view for more details.
4.14.1 Link Channels by
Calibraon
Calibrate the panoramic channel and the PTZ channel to establish the link.
Steps
1.
Go to Conguraon → PTZ → Panorama Tracking .
2.
Click Calibraon.
3.
Calibrate the channels
automacally.
1) Select the Calibraon Mode as Auto (Fast).
2) Adjust the PTZ
posions of the two channels and make the centers of the two channels at
approximately the same posion.
3) Click Start Calibraon.
The device starts
calibraon automacally.
4.
Oponal: If automac calibraon fails, you can use the manual calibraon.
1) Select the Calibraon Mode as Manual.
2) Select a calibraon point in Calibraon Parameter list.
A numbered green cross is displayed on the panoramic image. You can drag the green cross to
adjust its
posion.
3) Click Add to save the cross posion in the panoramic channel.
4) Adjust PTZ to place the green cross in the PTZ channel at the same posion as the green cross
in the panoramic channel. 1× zoom rao is recommended.
TandemVu PTZ Camera User Manual
25