HIKVISION DS-2SE7C43C432MW-AEB - Set Region Exiting Detection

Figure 8-6 Draw Area
9.
Click Save.
10.
Repeat above steps to set other regions.
11.
Set arming schedule. See
Set Arming Schedule .
12.
Set linkage method. See Linkage Method Sengs .
8.2.5 Set Region
Exing Detecon
Region exing detecon is used to detect the objects movement of exing from a predened area.
When it occurs, the device takes linkage acons as response.
Steps
1.
Go to VCA → Smart Event → Region Exing Detecon .
2.
Select a channel.
3.
Check Enable.
4.
Oponal: Click Lock to lock PTZ control to prevent the interrupon from other PTZ related acon
during conguraon.
Normally, the PTZ control is automacally locked when you enter the conguraon interface.
You can manually resume the lock when the countdown is over.
5.
Adjust the live image to the desired scene by using PTZ control
buons.
Note
PTZ control is only available for Camera 01.
6.
Draw detecon area.
1) Select a Region No.. Up to 4 regions can be set.
TandemVu PTZ Camera User Manual
65