HIKVISION DS-2XC6745G0-IZHS

It displays the real-me people number in the live view window. You can drag the mouse to
adjust the OSD window locaon.
Alarm Times Per Excepon
It refers to the alarm mes aer an alarm is triggered. If you do not check it and set the
mes, the device will keep sending alarms.
Alarm Interval
Within the set Alarm Interval, the same alarm will not be uploaded.
First Alarm Delay
When the
rst alarm is triggered, the alarm will be uploaded aer a set me period.
4.
Click to draw a region in the live view window, le click the end-points in the live view
window to
dene the boundary of the set rule region, and right click to nish drawing.
Note
●
Up to 8 regions can be set at the same me.
●
Try not to overlap the regions.
5.
Check Regional People Excepon Alarm, and set Alarm Trigger Condion and Alarm Threshold.
Note
●
Aer enabling Ignore Situaon of No People, the device will not trigger an alarm when there
is no people in the region.
●
This funcon can lter the potenal alarm condion under which the value is less than the set
Alarm Threshold and no people in the region.
6.
Set arming schedule. See Set Arming Schedule .
7.
Set linkage method. See
Linkage Method Sengs .
8.
Click Save.
9.
Oponal: Set text overlay. For detailed sengs, refer to Overlay and Capture .
10.
Oponal: View version and set ltering condion. For detailed sengs, refer to Advanced
Sengs .
Waing
Time Excepon Detecon
This funcon detects the waing me of the set rule region and an alarm is triggered when the
waing me meets the alarm-triggering condion.
Before You Start
●
Go to VCA → Select Applicaon , select People Management and click Next to enable the
funcon.
●
For the device supporng HEOP, go to VCA to import and enable People Management.
Steps
1.
Go to VCA → Set Applicaon → People Management → Regional People Counng → Rule .
Network Camera User Manual
92